Cubieboard has thickness 2.00mm 2×20-pin-header that is not so suitable for home hobbiest.
Arduino and other small boards uses 2.54mm pin (0.100inch)

To connect it I have bought 2.00mm to 2.54mm 40pcs Wire Cable 2P to 1P.

2.00mm to 2.54mm (2P to 2x1P) wires

Till it comes I will use my 2,54mm cables, you can connect 2 of them (not more) side by side:

 

Of course, you can buy BreadBoard For Cubieboard which would solve the issue here.

It would be very useful to buy something like this Connector (2.00mm to 2.54mm / 2×20):

I found it in this shop but was not able to find it in eBay. If anybody has a better solution, please leave a comment.

Related Posts

Which single board computer to select?

My first SoC board was pcduino. Since it was one of the first boards and I used it 24/7. It gave me some experience and I really like that Allwinner SoC A10 with 1GB RAM and[…]

Turn blue/green led off on cubieboard

If you have your cubieboard stable and do not like the led to blink, you can turn it off.

WiFi Access Point Bridge with Raspberry Pi 3 – ETH to WLAN

A Raspberry Pi WiFi Extender is a cheap and power efficient way of increasing the total range of your WiFi Network. In my case I needed to extend a WiFi coverage within the same LAN[…]